Garage Water Heater Leak Cleanup Cost Calculator
Enter the size of the wet area and what got wet to see a typical national price range for burst pipe cleanup and drying. It is an estimate only; the real price comes from the walkthrough.
Estimate the Cost
Typical range: $750 to $1,400
How it works: typical national figures of about $3.75 to $7 per square foot for clean water, $4.50 to $8.50 for gray water and $7 to $13 for black water, multiplied by 1.25 to 1.7 for drywall, ceilings, hardwood or finished basements and by 1.25 when the water sat for more than two days, with a small-job minimum. Pipe repair and rebuild are not included. Estimate only, not a quote.
Close the valve, then call (888) 432-4933
Garage Water Heater Leak Cleanup: Typical Price Ranges
For extraction, wall tear-out and drying, garage water heater leak cleanup usually lands between about $450 and $3,500 when the water stays in the garage. A soaked shared wall or water inside the house costs more.
- Small spill, slab only: $450 to $1,300. Extraction on the slab plus several days of air movers and a dehumidifier.
- Slab plus the shared wall: $1,300 to $3,500. Baseboard off, lower drywall cut and wet insulation removed.
- Water into the house: $3,500 to $9,000. The tank ran long enough to reach a laundry room, hall or bedroom floor.
- New drywall after drying: $2 to $5 per sq ft. Typical for hanging, taping and finishing the patch; paint and trim add more.
What changes the price
- Release: a full tank costs more to clear than a slow weep.
- Wall base: insulated drywall that wicked water gets cut, bare concrete block does not.
- Contents: soaked cardboard and fabric are removed and listed one item at a time.
- Time: water that sat overnight climbs the drywall and reaches the house door.